Paper Slitting Machine is a paper processing equipment that cuts and rewinds wide roll paper into rolls of different widths and diameters. Widely used in paper processing industry or pre-press and post-press mechanical equipment.
Features 1. Paper Paper Slitting Machine is controlled by PLC and touch screen, magnetic powder clutch type tension control, center winding method. 2. The main engine adopts frequency conversion speed regulation. It can automatically count meters, alarm and stop. All tension figures are displayed on the touch screen. 3. Unwinding adopts photoelectric automatic deviation correction (or ultrasonic deviation correction) to correct the neat edges of the paper, so that irregular materials can be cut normally. 4. Round knife (or straight knife) slitting, waste edge automatic discharge device. 5. Manual (or pneumatic) loading and unwinding shaft is equipped with a taper sleeve type air expansion shaft (3〞or 6〞). 6. Rewinding adopts A and B shafts (inflatable type) working principle The Slitting Machine consists of a frame, a transmission system, a feeding and unwinding mechanism, a tension control device, a traction member, a slitting bracket, a waste winding and discharging device, etc. It cuts the raw material into several independent units. Its working principle is to fix the raw material on the discharge shaft. One end of the discharge shaft is equipped with a magnetic powder tension controller to keep the tension of the raw material constant, and then it is pulled by a pair of rubber rollers. The raw material is cut into several strips by a blade. Then it is guided to A and B winding shafts by each guide roller to wind up the finished product. Its transmission is driven by the main motor to drive the traction rubber roller and the receiving shaft to run synchronously to achieve the purpose of traction feeding and finished product receiving.
1. Frame and transmission system: The frame is composed of left and right wall panels, supports and unwinding machinery. The transmission system is mainly used to pull raw materials and rewind finished products. The power passes through the V-belt of the motor to make the traction rubber roller run. The main traction rubber roller and the driven traction rubber roller are close to each other and run synchronously to drive the raw material to walk. The active traction roller drives the lower circular knife shaft to run synchronously to achieve better cutting requirements. , The winding A and winding B are driven to run synchronously through the lower circular cutter shaft, so as to achieve the purpose of winding. 2. Rewinding mechanism and its tension device: The rewinding mechanism is mainly composed of chains, synchronous wheels, magnetic powder clutches, and air expansion shafts. A separate motor controls the operation of the two winding shafts. As long as the current of the magnetic powder clutch is adjusted, The tension of the receiving shaft can be changed. 3. Traction member: The traction member is mainly composed of a pair of traction rubber rollers and several hard oxidized aluminum rollers, which are used to draw the raw materials and walk for the finished product to be rolled. Its power comes from the motor transmitted to the drive through the V-belt. Pull the rubber roller to make it run.
4. Slitting knife frame: The slitting knife frame has circular knife slitting and straight knife slitting. The operating handle can make the circular knife make a small amount of axial movement through the plane cam to adjust the cutting between the circular knife edge and the groove of the cushion sleeve. gap. 5. Waste rewinding and discharge: waste is discharged through the air duct using the wind force of the blower. 6. Unwinding mechanism and automatic deviation correction: The discharging mechanism mainly consists of a discharging shaft, a support block, a cylinder, a base, and a left and right moving seat, etc. The automatic deviation correction device consists of a photoelectric opening, a deviation correction guide roller, a left and right bracket, a deviation correction moving plate, and a ball Composed of nuts and screw rods, synchronous motors and left and right limit switches.
