1. The paper normally cut by the Paper Slitting Machine is correct, if there is a wrinkled paper in the slitted paper First check that the brake air pressure is correct. • If the brake is too small, the paper will be wrinkled; • Oversized paper will wrinkle and be too short; • Unbalanced air pressure on the paper feed roller. If the adjustment is not good, the paper will be wrinkled. It is necessary to check and find the cause in many aspects, and the problem of wrinkled paper will be solved.
2. The paper normally cut by the Paper Roll Slitting Machine is correct, if the length of the paper is different • First check whether the air pressure source normally reaches the required air pressure; • Check whether the air pipe of the brake pad is leaking, and whether the brake disc and brake pad are in normal contact and fit; • Check whether the synchronous belt is loose or the drive shaft with missing teeth is seriously worn and jumped; • Check for loose feed belt knife gears. All the above air pressure, gears, transmission shafts, and timing belts have been checked to be normal. If the paper is still long or short, it is necessary to consider checking whether the registration encoder is loose or stuck, which is inflexible. If this happens, replace it with the same specification. , The encoder of the same type, the wiring is firmly connected according to the color, usually 97% of the Slitting Machine is pulse control, the normal power supply voltage is also very important, the grounding wire is good and there is no interference signal, the machine has no fault.